Andrew ES45T Manual do Utilizador descarregar pdf (Página 50)

Step 9

Step 10

Step 11

Installation Procedures

Station an installer inside reflector to finger-tighten seam hardware and attach final pan-

els as shown in Figure 59.

Figure 59

Loosely attach reflector segment B-C to mounting ring hub and diameter setting bands.

Use edge joining plate (P/N 49424) on B-B panel seam and joining plate (P/N 49693)

on B-B rim seam.

Before attaching last panel, lift reflector and return temporary supports to initial measur-

ing position. Have installer inside reflector check tension on diameter setting bands. If

not uniformly taut, adjust level by adding shims until no segment of the reflector can

bounce and bands are uniformly taut, as shown in Figure 60.

Figure 60

ES45T-T Reflector Assembly

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 80 81

Sem comentários

Andrew ES45T Manual do Utilizador Página 50